The short version of Reverse-phase HPLC fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2026-05-30 and is reviewed periodically as new material appears.
The seven-residue chain carries several polar and charged side chains, so it dissolves readily in water and in aqueous buffers near neutral pH. No cysteine is present, so disulphide formation is not a concern and reducing agents are unnecessary. Dilute ammonium hydroxide or acetonitrile-water mixtures are sometimes used for stock solutions when initial dissolution is slow. Strongly alkaline conditions and prolonged contact with oxidising agents are avoided because they can modify lysine-containing stretches, and haze in solution usually signals incomplete dissolution or aggregated material.
Identity and purity are checked with reversed-phase high-performance liquid chromatography, which separates the target sequence from truncated or deletion analogues, and with mass spectrometry, which confirms the expected molecular mass. Amino acid analysis and peptide mapping give orthogonal confirmation but are used less often outside specialist laboratories. Counter-ion content varies: material purified on trifluoroacetic acid gradients retains trifluoroacetate, and ion exchange can convert the salt form. Residual water and solvent are measured by Karl Fischer titration or thermogravimetric analysis, and any purity figure should be read together with the method used to obtain it.
Material is normally supplied as a lyophilised powder in a sealed vial. The powder is hygroscopic, so exposure to humid air leads to water uptake, caking and gradual loss of the fluffy texture that indicates a good freeze-dry. Vials are best kept sealed with desiccant, protected from light and stored cold. Letting a cold vial warm to room temperature before opening reduces condensation on the contents. Purity is normally reported from a chromatographic run, and that figure applies to the batch as tested rather than to the vial after repeated opening.
Once dissolved, the peptide is far less stable than the dry powder. Aqueous solutions are subject to hydrolysis, oxidation at susceptible residues and gradual loss of material through adsorption onto glass and plastic surfaces. Terminal glutamine can cyclise under some conditions, producing a related species that complicates purity assessment. Dilute solutions tend to lose a larger fraction of material to surfaces than concentrated ones. Buffers, pH and ionic strength all influence the rate of change, so stability figures are only meaningful when those parameters are stated alongside the storage interval.
| Property | Value | Notes |
|---|---|---|
| Water content | Low in freshly lyophilised material | Rises after repeated opening of the same vial |
| Solution stability | Lower than powder stability | Frozen aliquots are preferred over repeated thawing |
| Purity assessment | Reversed-phase HPLC with UV detection | Peak-area percentage excludes salts and water |
| Salt form | Often the trifluoroacetate salt | Retained from acidic purification gradients |
| Light sensitivity | Not strongly photoreactive | Dark storage still advised for long-term keeping |
The designation TB-500 circulates in laboratory and catalog contexts without a single agreed definition. Most product listings apply it to an N-terminally acetylated seven-residue fragment of thymosin beta-4, while other listings attach the same label to the full 43-residue protein. Because the term is commercial rather than systematic, two entries bearing identical names may describe different molecules. Any documentation should therefore state which sequence a given sample is claimed to contain.
The fragment most often associated with the name carries the sequence Ac-LKKTETQ, matching residues 17 through 23 of thymosin beta-4. That region holds the actin-binding motif responsible for much of the parent protein's biochemical activity. Apart from N-terminal acetylation the peptide is unmodified and contains no disulfide bonds, so it shows little ordered secondary structure in solution. Full-length thymosin beta-4 is instead a 43-residue polypeptide of roughly 4.9 kDa found widely across mammalian cell types.
Material sold under this label typically arrives as a freeze-dried powder in a sealed vial with a certificate of analysis. Such certificates usually report reversed-phase chromatography purity plus a mass confirmation, and stated purities commonly sit between 95 and 99 percent. Counter-ion identity, residual trifluoroacetate, water content, and peptide net weight are separate specifications that a certificate may or may not include. A purity figure alone does not establish sequence identity, so independent mass verification remains the practical check.
Lyophilised material is stable for extended periods when kept dry and cold, and suppliers typically recommend storage well below freezing. Once dissolved, the peptide is handled at refrigeration temperatures and used within a short period, because peptide bonds and the acetylated terminus can be affected by repeated freeze-thaw cycles, proteases, or extreme pH. Bacteriostatic water and saline are both described as solvents, although preservatives can interfere with some analytical workflows. Reconstituted solutions are inspected for particulates before use.
Sports authorities classify the peptide as a prohibited substance, and it appears on the World Anti-Doping Agency list under peptide hormones, growth factors, and related substances. Racing jurisdictions for horses and dogs have issued separate restrictions, and several national bodies treat it as a controlled or prescription-only item. As a research chemical it is sold without a therapeutic indication, and labels usually state that the product is not for human or veterinary use. Regulatory treatment therefore varies by country.
Lyophilized peptide powder is normally held desiccated at −20 °C, with −80 °C used for longer storage periods. Allowing a sealed vial to reach room temperature before opening is standard practice, because condensation forming on cold powder introduces moisture. Once dissolved, solutions are typically kept cold and shielded from light. Repeated freeze-thaw cycles are avoided because they encourage aggregation and gradual loss of material. These conventions are general to synthetic peptides rather than unique to any one sequence.
Purity and identity are separate measurements and are often confused. Reverse-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, reports the share of total peak area belonging to the target compound. Mass spectrometry by electrospray or matrix-assisted laser desorption then checks whether the observed mass matches the expected sequence. Neither measurement alone shows that a vial holds the intended peptide. Peptide content, meaning the fraction of vial mass that is genuine peptide rather than counter-ion, water or residual acid, is reported separately and is frequently lower than the stated purity figure.
The regulatory position is broadly consistent across major jurisdictions: no thymosin beta-4 fragment is an approved medicine, and laboratory material is commonly labelled as not intended for human consumption. Anti-doping rules in sport list thymosin beta-4 and its fragments among prohibited peptide hormones. Because these products travel through research-chemical channels rather than pharmaceutical supply chains, quality varies considerably between vendors. Independent testing of identity, purity and sterility is the only dependable check, and a certificate of analysis describes one batch rather than a supplier's whole catalogue.
The SC was decommissioned in 1990, after having been in operation for more than three decades. As a consequence, the collaboration decided to relocate the ISOLDE facility to the Proton Synchrotron, and place the targets in an external beam from its 1 GeV booster. The construction of the new ISOLDE experimental hall started about three months prior to the decommissioning of the SC. With the relocation also came several upgrades. The most notable being the installation of two new magnetic dipole mass separators. One general-purpose separator with one bending magnet and the other one is a high-resolution separator with two bending magnets. The latter one is a reconstructed version of the ISOLDE 3. The first experiment at the new facility, known as ISOLDE PSB, was performed on 26 June 1992. In May 1995, two industrial robots were installed in the facility to handle the targets and ion sources units without human intervention.
When B cells and T cells are activated by a pathogen, memory B-cells and T- cells develop, and the primary immune response results. Throughout the lifetime of an animal, these memory cells will "remember" each specific pathogen encountered, and can mount a strong secondary response if the pathogen is detected again. The primary and secondary responses were first described in 1921 by English immunologist Alexander Glenny although the mechanism involved was not discovered until later. This type of immunity is both active and adaptive because the body's immune system prepares itself for future challenges. Active immunity often involves both the cell-mediated and humoral aspects of immunity as well as input from the innate immune system.
The light chain gene has three gene segments. These include: the light chain variable region (V), joining region (J), and constant region (C) gene segments. The variable region of light is therefore encoded by the rearrangement of VJ segments. The light chain can be either kappa,κ or lambda,λ. This process takes place at the level of mRNAs processing. Random rearrangements and recombinations of the gene segments at DNA level to form one kappa or lambda light chain occurs in an orderly fashion. As a result, "a functional variable region gene of a light chain contains two coding segments that are separated by a non-coding DNA sequence in unrearranged germ-line DNA".
Sources: en.wikipedia.org
In the presence of a full agonist exerting its maximal effect, a partial agonist can behave like a competitive antagonist to lower the effect of receptor binding, generating merely a submaximal reaction. These variations can be evaluated regarding effectiveness, indicating the agonist-receptor complex's "strength" in causing a tissue response. It relies on receptor occupancy and response. A particular medication of intermediate efficacy may appear as a partial agonist in one tissue (lower level of receptor expression) and a full agonist in another (high level of receptor expression) across distinct cell types expressing the same receptor but at varying densities.
Preclinical laboratory studies analogous to those conducted on the pro-malignant effects of 12(S)-HETE and growth-inhibiting effects of blocking 12-HETE production in cultured prostate cancer cell lines, have implicated 12-HETE (stereoisomer sometimes undefined) in cancer cell lines from various other human tissues including those from the liver, intestinal epithelium, lung, breast, skin (melanoma), ovary, pancrease, and possibly bladder. These studies implicate the interaction of 12-HETE with BLT2 receptors in intestinal epithelium cancer cells, and BLT2 receptors in breast, ovary, pancreas, and bladder cancer cells. While the studies on these tissues have not been as frequent or diverse as those on prostate cancer cell lines, they are suggested to indicate that 12-HETE contributes to the growth or spread of the corresponding cancer in humans.
The use of RdRp plays a major role in RNA interference in eukaryotes, a process used to silence gene expression via small interfering RNAs (siRNAs) binding to mRNA rendering them inactive. Eukaryotic RdRp becomes active in the presence of dsRNA, and is less widely distributed than other RNAi components as it lost in some animals, though still found in C. elegans, P. tetraurelia, and plants. This presence of dsRNA triggers the activation of RdRp and RNAi processes by priming the initiation of RNA transcription through the introduction of siRNAs. In C. elegans, siRNAs are integrated into the RNA-induced silencing complex, RISC, which works alongside mRNAs targeted for interference to recruit more RdRps to synthesize more secondary siRNAs and repress gene expression. Spiegelman's Monster NS5B inhibitor RNA+Replicase at the U.S. National Library of Medicine Medical Subject Headings (MeSH) EC 2.7.7.48
Sources: en.wikipedia.org
Divide it into single-use aliquots and hold them frozen at -20 °C or below, protected from light. Repeated thawing of one container is the main avoidable source of variability.
Mass spectrometry confirms identity, because the measured mass is compared with the value expected from the sequence. Chromatography mainly reports how much of the material elutes as the target peak.
It usually describes the share of the chromatographic peak area recorded at a set wavelength. Salts, residual water, and solvent are excluded from that number, so it is not the same as mass fraction.
Sealed, dry and protected from light at reduced temperature is the usual laboratory convention. Allowing a cold vial to reach room temperature before opening limits condensation. Repeated opening exposes the powder to moisture and should be minimised.