peptide mapping comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Updated 2026-03-27. Numbers and descriptions here follow the published literature rather than marketing material.
TB-500 is a synthetic heptapeptide with the sequence Ac-LKKTETQ. It corresponds to a short N-terminal region of thymosin beta-4, a 43-amino-acid protein found in many cell types. The fragment contains an actin-binding motif, which is one reason it appears in laboratory studies of cell migration and cytoskeletal dynamics. TB-500 is not the full-length protein and is produced as a research chemical rather than an approved therapeutic agent. Its molecular weight is approximately 889 Da.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
Regulatory status differs by country, but TB-500 is not an approved pharmaceutical in major jurisdictions. It is commonly sold as a research chemical for laboratory use, which places responsibility for identity and purity on the supplier and the laboratory. Published human data are limited, and most reports involve preclinical models or cell culture. Questions about whether the fragment mimics all actions of thymosin beta-4, and under which conditions, remain open. Independent verification of any material is therefore a practical requirement in research settings.
Lyophilized peptide arrives as a dry cake that should stay sealed until use. Reconstitution is generally performed with sterile water or a buffered solution, and the resulting liquid should be handled gently to limit mechanical stress. Repeated freeze-thaw cycles are widely described as harmful to short peptides, so dividing a reconstituted batch into single-use portions is a common practice. Laboratories also record the solvent, concentration, and date of preparation on the vial label to keep later measurements traceable.
Dry powder is commonly held at minus twenty degrees Celsius, with some suppliers recommending lower temperatures for long-term archival storage. Once dissolved, solutions are typically kept cold and protected from light, since aqueous peptide solutions can lose integrity through hydrolysis or oxidation over time. Stability data specific to this fragment are limited in the public literature, and much of the guidance comes from general peptide handling practice rather than from controlled degradation studies. Users therefore treat stated shelf lives as approximate rather than fixed.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H68N10O14 | Calculated for the acetylated heptapeptide |
| Molecular weight | ~889 Da | Monoisotopic mass approximately 889.0 Da |
| Amino acid sequence | Ac-LKKTETQ | N-terminal acetylated seven-residue peptide |
| Appearance | White to off-white powder | Typically supplied as a lyophilized solid |
| Solubility class | Water-soluble | Peptides of this size generally dissolve in aqueous media |
Thymosin beta-4 contains 43 amino acids and has a reported molecular mass near 4963 Da. The short fragment most often associated with the TB-500 label, an acetylated chain beginning LKKTETQ, has a reported mass near 889 Da, so the two are easily separated in analytical work. Mass spectrometry and amino acid analysis can confirm which material is present in a given sample. Statements treating TB-500 and thymosin beta-4 as interchangeable are therefore imprecise, even though the two appear together in much of the same literature.
Interest in the compound comes largely from studies of the parent protein, which participates in actin sequestration, cell migration and tissue repair processes. Whether a short fragment reproduces those activities is a separate question that remains open in the published record. Many summaries describe mechanisms by analogy to thymosin beta-4 rather than from direct measurements on the fragment. Claims about activity should be treated as provisional unless a cited study specifies the exact peptide, its purity and the assay used.
Lyophilised peptide powders are hygroscopic, and the fragment absorbs atmospheric moisture when a vial is opened at room temperature. Weighing and aliquoting are normally done quickly in a dry environment, and stock solutions are divided into single-use portions before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and can shift the measured content of a vial. These practices are general to synthetic peptides rather than unique to this sequence, but they matter more for short chains kept for long periods.
The seven-residue chain carries several polar and charged side chains, so it dissolves readily in water and in aqueous buffers near neutral pH. No cysteine is present, so disulphide formation is not a concern and reducing agents are unnecessary. Dilute ammonium hydroxide or acetonitrile-water mixtures are sometimes used for stock solutions when initial dissolution is slow. Strongly alkaline conditions and prolonged contact with oxidising agents are avoided because they can modify lysine-containing stretches, and haze in solution usually signals incomplete dissolution or aggregated material.
Identity and purity are checked with reversed-phase high-performance liquid chromatography, which separates the target sequence from truncated or deletion analogues, and with mass spectrometry, which confirms the expected molecular mass. Amino acid analysis and peptide mapping give orthogonal confirmation but are used less often outside specialist laboratories. Counter-ion content varies: material purified on trifluoroacetic acid gradients retains trifluoroacetate, and ion exchange can convert the salt form. Residual water and solvent are measured by Karl Fischer titration or thermogravimetric analysis, and any purity figure should be read together with the method used to obtain it.
Lyophilized peptide powder is normally held desiccated at −20 °C, with −80 °C used for longer storage periods. Allowing a sealed vial to reach room temperature before opening is standard practice, because condensation forming on cold powder introduces moisture. Once dissolved, solutions are typically kept cold and shielded from light. Repeated freeze-thaw cycles are avoided because they encourage aggregation and gradual loss of material. These conventions are general to synthetic peptides rather than unique to any one sequence.
Purity and identity are separate measurements and are often confused. Reverse-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, reports the share of total peak area belonging to the target compound. Mass spectrometry by electrospray or matrix-assisted laser desorption then checks whether the observed mass matches the expected sequence. Neither measurement alone shows that a vial holds the intended peptide. Peptide content, meaning the fraction of vial mass that is genuine peptide rather than counter-ion, water or residual acid, is reported separately and is frequently lower than the stated purity figure.
The regulatory position is broadly consistent across major jurisdictions: no thymosin beta-4 fragment is an approved medicine, and laboratory material is commonly labelled as not intended for human consumption. Anti-doping rules in sport list thymosin beta-4 and its fragments among prohibited peptide hormones. Because these products travel through research-chemical channels rather than pharmaceutical supply chains, quality varies considerably between vendors. Independent testing of identity, purity and sterility is the only dependable check, and a certificate of analysis describes one batch rather than a supplier's whole catalogue.
endogenous Originating or arising inside of an organism or cell; produced by the organism or cell itself, rather than sourced from the external environment; of or pertaining to native or internal factors or processes, to be distinguished from foreign or exogenous factors or processes.
=== Amino acid enrichment for certain functional categories of LCRs === A bioinformatics analysis of prokaryotic LCRs identified 5 types of amino acid enrichment, for certain functional categories of LCRs:
For coupling to mass spectrometry, the ions from the plasma are extracted through a series of cones into a mass spectrometer, usually a quadrupole. The ions are separated on the basis of their mass-to-charge ratio and a detector receives an ion signal proportional to the concentration. The concentration of a sample can be determined through calibration with certified reference material such as single or multi-element reference standards. ICP-MS also lends itself to quantitative determinations through isotope dilution, a single point method based on an isotopically enriched standard. In order to increase reproducibility and compensate for errors by sensitivity variation, an internal standard can be added. Other mass analyzers coupled to ICP systems include double focusing magnetic-electrostatic sector systems with both single and multiple collector, as well as time of flight systems (both axial and orthogonal accelerators have been used).
Sources: en.wikipedia.org
Gumbleton, along with 33 other Essendon players, was found guilty of using a banned performance-enhancing substance, thymosin beta-4, as part of Essendon's sports supplements program during the 2012 season. He and his team-mates were initially found not guilty in March 2015 by the AFL Anti-Doping Tribunal, but a guilty verdict was returned in January 2016 after an appeal by the World Anti-Doping Agency. He was suspended for two years which, with backdating, ended in November 2016; as a result, he served approximately fourteen months of his suspension and missed the entire 2016 season with Banyule.
=== Static light scattering === Static light scattering allows monitoring of the sizes of the species in solution. Since proteins typically aggregate upon denaturation (or form fibrils) the detected species size will go up. This is label-free and independent of specific residues in the protein or buffer composition. The only requirement is that the protein actually aggregates/fibrillates after denaturation and that the protein of interest has been purified.
== Applications == Currently, it is used industrially to verify, with a high throughput, the concentrations of brominated flame retardants (BFR) in plastics in compliance with the European Union's RoHS (Restriction of Hazardous Substances) regulation in place since 2006. The banned molecules include PBB and PBDE, whose concentration should not exceed 0.1% w/w. IAMS has also been used to analyze diesel exhaust particles, in ceramic processing, and in critical silicon etching during semiconductor manufacturing.
== Contraindications == Pentoxyverine is contraindicated in persons with bronchial asthma or other kinds of respiratory insufficiency (breathing difficulties), as well as angle-closure glaucoma. No data are available for the use of pentoxyverine during pregnancy, lactation, or children under two years of age, wherefore the drug must not be used under these circumstances. Antitussive drugs are not useful in patients with extensive phlegm production because they prevent coughing up the phlegm.
Sources: en.wikipedia.org
TB-500 is a synthetic heptapeptide corresponding to a fragment of thymosin beta-4. It is used in laboratory research and is not an approved drug.
No. Thymosin beta-4 is a 43-amino-acid protein, while TB-500 represents only a short N-terminal segment. The two should not be treated as interchangeable in experimental design.
It is often called a thymosin beta-4 fragment, Tβ4 fragment, or Ac-LKKTETQ. The name TB-500 is mainly a commercial or catalog label rather than a formal chemical name.
Dry lyophilized powder is usually kept frozen, desiccated, and out of direct light. Sealed vials are not opened until needed, because moisture uptake can degrade short peptides. Longer archival storage is often done at lower temperatures than routine working stock.